Mulimeter is a beneficial tool that used for troubleshooting circuits, whether it is located in DVD player or in automobile.
This tool can provide readings for current, voltage, and also resistance via direct interaction with the circuits.
When you are using this device, it is very important for you to take precautions and be attentive since it is designed to interact with the live wires.
In order to reduce the occurrence of the hazardous incidents, it is required careful examination of the multimeter settings and also practicing the safe testing process.
At this time, this article is going to give you several tips that will guide you to safely use multimeter.
So, just check out the easy tips below.
The first thing that you have to do is to set your multimeter to the type of measurements that you want to take.
You should make sure that your multimeter matches are appropriately set for either alternating of the direct current when you are measuring the voltage or current.
The second thing that you need to do is to set down or hang up your multimeter before you are going to take readings.
You have to make sure that a short circuit will occur during the testing since it can reduce the chances of injury, particularly in the instances where the multimeter does not have a fuse as safety features.
The third thing that you have to do is to connect the test leads.
Apparently a simple step, the improperly connecting test leads will lead to the catastrophic failure of multimeter, based on the resources from Northwestern University Mechatronics Design Laboratory.
The accidentally testing voltage with the test lead that plugged into a jack used for the testing resistance can cause such a failure.
Lastly, you should disconnect the ground clip after all of the other circuits have been disconnected.
So, by following the easy tips above, now you can use your multimeter safely.